 Quote: |
|
Originally Posted by juvehab Hey guys I am intalling a little system in my car and wondering how I should set it up.
Deck - Alpine 9855
Amp- Audison srx3
Front- Dls UR6
Sub- JL 10w3v2
Cap- Monster .5farad
Now my ? is
-if I run that amp @ 4ohm's is 75w a side enough power for the Dls or should I run the fronts in a 2ohm load to get 110w and the sub @ 4 ohm
-what gauge wire should I use?
-Also where is the best place to mount those tweets without butchering my door panels?
-should I run an rca from my sub out on my deck to my Amp?
Thanks in advance |
first off, your front speakers are probably 4 ohm, so you can't just run your amp at what you want, it's load is determined by the speaker's impedance.
You have a 540 watt rms (potential, all channels @ 2ohms) amp, so i would run a 4awg wire to be safe, 8 awg would be fine if the amp is very efficient, but since your running wire...think ahead to future upgrades or options (like adding rear speakers and loading the amp to 2ohms or changing to a two ohm sub etc...)
A-pillars, sail panel(inside panel on side mirrors), possibly dash, or you could go with kick pods( I don't like them myself, but you might).
yes, run all rca's back to the rear, again think ahead to future upgrades, you're only going to use the front and sub pre-outs, but that deck offers a lot of control to your system through those pre-outs.
Good luck, sounds like it should be a nice system!
