looking for some answers on why my woofers pop on power up. System is 2 months old brand new. just started poping today after a crap load of rain. checked all equipment nothing is wet. 600 mono PG gold pumping 2 pioneer 12s. Iam guessing check my ground first.

does it make the sound when you switch tracks as well?
i had issue like that and ground was my solution. have you done big3 yet?

__________________
Hifonics BXI2006 (2000W @ 1ohm ) Alpine SWR-1542 Type R's in 4cube sealed box
1997 Ford Thunderbird v8 4.6L SCT Tuned @ 15.47sec 1/4 sitting on 20inch TIS 01's

Thanks for the info. Changing tracks does not pop the woofers.
think I should ground the (-neg batt) direct to the frame of my windstar with batt cable?

Could be blown.

IMO grounding to the frame does nothing if your amp isnt ground there also. the reason why it is supposed to is that there is alot less crap for the power to go threw(goop that manufacturers use instead of welds, shity welds, and many different peices of steel). the best thing to do for grounding is to ground right to your batt.

__________________
87 Nissan Hardbody/truggy. Tube frame. full EXO. 39.5" IROKs. 18" FOA coilovers ft/rr. D60's. 5.89

4.3/4l60e/207/205-all sold. now putting a TBI 350, 700r4(.5"valve, corrvette servo, red band, shift kit), 203/205 triple stick.

______________________________/\/ / _\'' /\/\ ()_______________________________

i dont see a answer here... fubar u figure out your problem?? i just got a new system put it in and yes i got that o so lovely pop when i turn my amp on... i thought i read someone on here about wires being to close or something but ill keep looking, and my ground is real good so it shouldnt be that.

__________________

check your RCA also some times its ground through the rca

__________________
its all in your head now just do it

16volt Turbostart Charger $250

member of Team Absolute
www.absolutecaraudio.ca

thanks.. but i got my answer already ... the t3-500 doesnt come with a quite power up circuit....

__________________