Specs on the amp:
Total Peak Power 500W
RMS Pwr per CH @ 4 Ohm 150W
RMS Pwr per CH @ 2 0hm 230W
RMS Pwr Mono @ 4 0hm 450W
THD @ 4 0hm <0.03%
@ 2 0hm <0.08%
S/N Ratio >93dB
Channel Separation >60dB
Frequency Response ±0.5d 10Hz-20kHz
Crossover Frequency LPF 35Hz-250Hz
Crossover Frequency HPF 35Hz-250Hz
Bass Boost 40Hz @ 6dB
Low Level Input Range 200mV - 4V
High Level Input Range 0.5V-4V
Input Impedance 47k Ohms
Damping Factor 228
Fuse 25 Amp x 2
Dimensions (H x W x L) 12.1" x 2.5" x 13.7"

the guy was pushing two 350 W rms subs, 12''. This is clifford design, 2 channel. $120 obo.

Im planning on pushing a 250W rms sub XPLOD. My speakers are 2 6x9 clifford design styles.

Another thing i need to know is how do i know what way to wire the speakers and deck up so i dont pop 'em?

thanks

what exactly are u asking

__________________
Team Fear Of Bass

2006 & 07 - Canadian Street A & B Record Holders
2007 Street A - 155.2 db's
2007 Street C - 154.8 db's
2007 CSPL Amature 1 Champion - 150.8 db's

100 dollar amp for 6by9 s.if it works take it

sure..buy it then have it proffesionally installed..nones gonna explain to you how to do it on here..it'll take too long

__________________


TEAM NOT LOUD
TEAM ELECTRO-PRO
TEAM MAXIMUM THRESHOLD

2005 - 161.2 dB CERTIFIED - 2-RE MT12's on 4 American Bass 200.1

2007 - STREET C - 15" RE MT in a 1995 NEON!
154.2dB 4 AmericanBass 500.1's with way too much voltage drop

2008 - Street C - 15" FI BTL in a 1999 VW Jetta TRUNK!
149.0 on 1 - Powerbass XA3000d
not a bad start for a raw box