well, heres my situation. all i know is apparently rockford fosgate is good, which is what i have. did i gte the right things ?? i hope you will forgive my newbieness may i be pointed into a direction of somewhere that i can learn everything i neeed to know about car audiio. thanks and also, i was curious as to what amp i should run to power the two rockford fosgate punch 2, 10 inch subwoofers dual voice coil and 2 rockford 6x9 T1693C that i am going to put under the rear seat in a jeep. the subs will be placed above the wheel wells, would it be possible to have one amp to run all 4 ? or owuld i have to run seperate amps ? thanks for the help qhich amp would you reccomend for value for kinda on the budget side

You need to run 2 amps. Use a mono block amp for the subs and a 2 channel for the 6X9's. If you plan on adding coaxials then I would suggest you use a 4 channel amp to run your mids and highs. Hope this helps.

well, i was kind of hoping to get away with one amp, or is it necessary to run two amps at the risk of blowing the single amp ? thanks for your input and i apreciate it

depending on the amp its self you might be able to get away with a 4ch amp. using to channels for the speakers and bridging 2 for the sub.

but for the best setup it is recommend to get a 4ch amp and a mono amp.

__________________
2004 Chevy Epica
Pioneer DEH-7600
Morel 2-way front
Morel Coax Rear
Dual Kicker 12" L7's

Powered by:
Memphis 16 ST-3004
Memphis 16 ST-1500D
The Big 3 in 0 AWG
2 Farad Cap

Installed by:
Selective Sound