hey,

i had some compatibility questions between my amp and deck that have been answered. below i posted a question about bass boost on amps.. i'm sure someone will share their expertise/views with me hehe.

thanks so much!

__________________
Vehicle A - Kenwood eXcelon KDC-X979 HU; Kenwood eXcelon 5.25 components in q-forms; Rockford Punch 75.2; Kenwood eXcelon KAC-X810D; American Accessories 1.2f capacitor; 1 Pioneer Premier TS-W2000SPL in a Bass Slammer box @ 38Hz

Vehicle B (daily driver budget system) - Alpine CDA-9830 HU; Rockford Fanatic X 6.5 components; Pioneer GM-H200; (2) Kaption COMP-108 10's wired to 4ohm in a Kaption factory box tuned to 35Hz; Audiocontrol 2xs (only deck installed so far on this one i'm getting started soon)

ok i think its sorted out!

apparently all i need is a length of 18ga copper wire, to connect the amp into the deck's "external amp control" on the deck's harness.. thanks!

*** so anyway my sub is in a 1.75 cu/ft box, tuned to 38Hz.. what would +6, +12, or +18 dB of bass boost do? the lowest the setting goes is 40Hz. where would be the best to set it for my application? or is it best to wait until the deck goes back in and do it by ear? i guess my main concern is distortion, what do you guys think of bass boost, is it good or bad? and how do you use it properly? (assuming gains are set at 5.0v with 5.0v preouts on deck)

thanks in advance!

__________________
Vehicle A - Kenwood eXcelon KDC-X979 HU; Kenwood eXcelon 5.25 components in q-forms; Rockford Punch 75.2; Kenwood eXcelon KAC-X810D; American Accessories 1.2f capacitor; 1 Pioneer Premier TS-W2000SPL in a Bass Slammer box @ 38Hz

Vehicle B (daily driver budget system) - Alpine CDA-9830 HU; Rockford Fanatic X 6.5 components; Pioneer GM-H200; (2) Kaption COMP-108 10's wired to 4ohm in a Kaption factory box tuned to 35Hz; Audiocontrol 2xs (only deck installed so far on this one i'm getting started soon)