hey there, got some new equipment on the cheap (yay for bargan!)

Question is:

Right now I have my 2 PG Octane-r 10's bridged on my 4ch kicker amp. I have splitters for my sub RCA, running the white splitter into both whites, and the red splitter into both reds on the amp.

My problem is, is the right sub is doing alot more work, and the subs are not playing in mono, there are times when only 1 subs is moving, as if the subs are working in stereo. How do I stop this? I will check the phase too, as I may have mixed that up...but I am pretty sure I didn't.


So to restate, are my subs playing as if they're stereo? I want them Mono, do I just switch one of the red and white RCA's? My HU is a JVC KD-G710, and there is no sub-out, so I am running the rear out as my sub.


Help me?!

The gains and crossovers, must be set with a multimeter, and you may use a spliter in the inputs to the amp, and in the output from the deck...But the easier way is to get a 2 amps mono amplifier.... and then this for channel you can use it for the mids...doble mono??? maybe...but be careful with the gain

yeah the gains are set way to high, gotta mess around with that some more, its hard though because the kicker amp was re-powdercoaated, so i dont really know what knob does which....i used a picture off the net for reference, but this is the older model, so I think it might be a little different

see...well you can try with a 50 hz pure tone, and the multimeter, adjust both gains and crossover, so you get the same for both channels, but be careful, not to put much "cow bell"(?) on it. Is better if you go low.