okso im gonna put my system in tomrmow, i just wanna go over a few things to make sure imdoing this right.

im going to disconnect the negative termanal from the battery
hook up the power wire to the posotive side
i wont put the fuse in so that way when i connect the power wire to the amp i wont blow any fuses.
im gonna install the ground wire
im gonna connect thesubs
im gonna hook up the other end ofthe power wire to the amp.
then im gonna put the fuse in then connect the fuse together.
im gonna connect the neagtive battery termanal.

does that sound right?

*Edit* not sure if my advice was good after thinking about it haha.

__________________
Talk to me! msn --> aaronone321@hotmail.com

Alpine 9805
Kicker S10L5 (2004) in ported box
Power Acoustik LT980/2 500 rms @ 4 ohms mono
Power Acoustik LT720/4 70 rms @ 4 ohms x 4
JBL 5 1/4" components

sounds good. i found over the years of my installation i`ve done installs in many different orders and never has any problems other than a few sparks here and there.

but now the wires to amps are installed before i hook the battey back up.