On my Amp it has REM. Im supposed to run this wire from the deck to the amp, but where do i plug it into on my deck? Like i have no clue what this is, can i just not have one? Is it just normal wire?

Hifonics 500Watt X 2

Wat deck???

Stock?

Clarion DRX5675, 45W X4.

K..You should see a Solid Blue wire..thats the REM....just solider..or twist and tape the rem wire that you got from your amp kit(usually 16-18 gauge)...and hook it up to your amp..

Hope this helps

So this blue wire comes from my deck and where did it go in the first place? Is it nessasary to hook it up to my amp cuz i dont really see any blue wire other then one really small one with all the other small coloured ones.

thanks

Yes its a small blue wire from your deck..And yes its nessacery to hook-up to your amp..because it turns on the amp when your deck turns on..And yes its thats small wire that is with the decks other small wires


hope this helps

i think it might, im goin to go give er hell

What REM means is remote. It is the voltage input for an amplifer's internal relay switch. All this does is provide a 12 volt source to turn the amplifer on (not power the amplifier. That comes from your main power run). If you cannot find the REM wire on your deck, you can tap a 12 volt source from your fuse panel and feed it to your amp. Make sure you install a switch if you do it this way as this is required to turn your amp on and off. If you connect it through your deck, you would not need the switch as the deck does the switching for you....
Hope this helps...

__________________
smpl_gy running a smpl system...
one amp, one sub and 1.6 kilowatts of 50hz and below...

yeah thanks guys i got everything working.

1000watt amp, a 12 and a 10 inch.

But now my car wont start after running it for a while, what could cause that>? I no im an idiot

Did you run it with the car on?? OR off..

I most likey think the batterys dead....